Glow-worm Clearly Heat Recovery - Manual (Page 6)

www.glow-worm.co.uk
6
Operation
The Atmosorb can only be used if all ventilation pipes are
connected and the unit is closed.
The Atmosorb unit must only be operated with the supplied
filters installed. Regularly check whether the filters are dirty
or damaged.
We recommend to visually check the filters every 6 months
and to replace them every 12 months, or after 2000
operating hours at the latest. If the system is to be used
for ventilation purposes in locations with room-dependent
combustion facilities, the corresponding flue gas extraction
systems must be checked and maintained by a competent
person approved at the time by the Health and Safety
Executive.
Do not modify:
- the unit,
- the outside air, fresh air, exhaust and discharge air
ducts, the pipes for condensation water and the unit mains
connection.
This also applies to alterations to structural elements in the
vicinity of the unit which might affect its operational safety.
- do not obstruct the air inlets and outlets with doors, ceilings,
windows and walls even temporarily. Do not cover the air
inlets and outlets, e.g. with clothes or similar. When laying
floor materials, do not block or reduce the vent apertures at
the bottom of the doors.
Important Information
To make alterations to the unit or to its environment, you
must refer to the suitably qualified expert technician who is
qualified to do this work.
Servicing
This product should be serviced regularly to optimise its
safety, efficiency and performance. The service engineer
should complete the relevant Service Record on the
Benchmark Checklist after each service. The Benchmark
Checklist may be required in the event of any warranty
work and as supporting documentation relating to home
improvements in the optional documents section of the
Home Information Pack.
To ensure the continued efficient and safe operation of the
boiler it is recommended that it is checked and serviced at
regular intervals. The frequency of servicing will depend
upon the site conditions and usage, but in general, once a
year should be enough.
Only
competent persons approved at the time by the
Health and Safety Executive are authorised to execute
repair and maintenance work (with the exception of replacing
the filters). It is recommended that you carry out a visual
inspection of the filters at least every 6 months and replace
the filters every 12 months, or at least after 2,000 hours of
operation.
To obtain service, please call your installer or Glow-worm’s
own service organisation using the telephone number on the
inside front cover of this booklet.