FeiYu Tech FY-DOS User Manual
Page 9
Guilin Feiyu Electronic Technology Co., Ltd
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyudz.cn E-mail: [email protected] Page 9
8. RC receiver connection:
RC receiver and DoS connection wires is included in the DoS product.
Attention: the
wires is arranged by the colors.
a) DoS requires a minimum of 6-channel RC receiver.
b) 4 Receiver channels are used for aileron (channel 1), elevator (channel 2)
，throttle
(channel 3) and rudder (channel 4) signal output. Connect these 4 receiver output
signals to the DoS with the supplied wires (pay attention to the color of each channel ).
c) a free Receiver channels are required to control the DoS Flight Modes (a 3-position
switch ,”SW1”).
d)the other 3-position switch(SW2) is not used in firmware V2.0,so you do not need to
connect.
Wire color
Receive channel
White
(bundled with red
& black)
aileron
Channel
1
orange
elevator
Channel
2
green
throttle
Channel
3
yellow
rudder
Channel
4
brown
SW 1
Any free channel
controlled by
A 3-way switch or dial
knob
Channel
5
blue
SW 2(not used)
Any free channel
controlled by
A 3-way switch or dial knob
Channel
6
Attention:RC mode Setting of your controller has to be fixed wing model, and every
channels’ maximum and minimum value to be the default value (100%), all the sticks trim
to 0
,
also cancel all the curve set .
9. Motor start-up instruction:
Start Motor：When using multi-rotor firmware, pushing throttle stick before takeoff will