beautypg.com

Light bulb replacement, Headlight turn signal, Brake light – E-Z-GO FREEDOM TXT 2+2 User Manual

Page 39: Fuse replacement, Maintenance

background image

31

MAINTENANCE

Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.

LIGHT BULB REPLACEMENT

To reduce the possibility of premature bulb failure, do not touch new bulbs with bare fingers. Use clean, dry

tissue or paper towel to handle the glass portion of the bulb.

Headlight

To prevent bulb from inadvertantly disconnecting and possibly melting or igniting plastic components, the

locking ring MUST be reinstalled after installation of replacement bulb.

Pull the locking ring straight off the back of the light hous-

ing and allow it to slide down the harness and out of the

way.
Rotate bulb socket a quarter turn counterclockwise to

unlock. Pull out bulb and socket. Insert new bulb and rotate

socket a quarter turn clockwise to secure.
Slide locking ring over new bulb socket and onto back of

light housing.

Turn Signal

Locate the turn signal bulb socket on backside of light

housing. Rotate a quarter turn counterclockwise to unlock

and remove from housing. Insert replacement bulb and

rotate a quarter turn clockwise to secure in place.

Brake Light

Remove two phillips head screws securing lens and pull

lens out of housing to access the brake light bulb. Remove

the light bulb and install a new bulb, making sure bulb

makes good contact with socket. Replace the lens and

reinstall the phillips head screws.

FUSE REPLACEMENT

To replace fuses, raise the seat bottom, the fuse block is located on the

fender liner on the driver side of the vehicle. Pull out old fuse and replace

with a new fuse of the same type and size.

Turn Signal
Bulb

Headlight
Bulb

Rear Fender

Lens

Bulb

Fuse Block

This manual is related to the following products: