EMP Tek VT-40.2 - Manual (Page 5)

Choose a location where air can circulate freely around the amplifier. Do not cover
the amplifier.
Amplifier Location
4
Attaching Speaker Wires
When using a banana jack to attach speaker wires to the binding post terminals, loosen
the top as shown in step 1, and then insert the speaker wire into the banana jack as
shown in step 2. Next insert the banana jack into the binding posts on the amplifier
into the hole provided in the top of the terminal, and then tighten down the screw as
shown in step 3 until secure. Repeat for the other speaker wire(s) as necessary.
If not using a banana jack, simply loosen the binding nut to allow the hole in the side
of the terminal to become exposed as shown in step 1. Strip ¼-inch of the insulation
from the end of the speaker wire and insert the exposed wire end into the now exposed
hole in the side of the terminal as shown in step 2. Tighten the binding nut by turning
the nut clockwise until the speaker wire is secured as shown in step 3. Repeat for the
other speaker wire(s) as necessary.