Elenco Digital Bench Multimeter - Manual (Page 12)

DVM645BI GB 11
Red
Circuit
Measuring AC Volts
Figure 2-2. Measuring AC Volts
WARNING
To avoid possible electric shock, multimeter damage and/or
equipment damage, do not attempt to do any voltage measurements if
the voltage is above 1000V DC / 750V AC RMS. 1000V DC / 750V AC
RMS are the maximum voltages that this multimeter is designed to
measure.
c
Turn the Selector to Volts AC
d Connect the leads as shown
e is not available in Volts AC, all other buttons can be used.
1. Insert the black and red test leads into the COM and V
Ω Ω Ω Ω Hz input terminals
respectively.
2. Select the desired AC voltage range, or set to auto range.
3. When the magnitude of the voltage to be measured is unknown, always start
with the highest range.
4. Connect the test leads in parallel with the circuit to be measured. Be careful
not to touch any live conductors with your hands. Note the reading.
5. When all measurements have been completed, disconnect the test leads from
the circuit under test. Remove the test leads from the multimeter.