Electrocompaniet ECC 1 - Manual (Page 5)

How to power up your system
You should always power up your system in the following order:
First turn on the ECC-1, and then turn on the amplifiers.
When switching off your system
First turn off the amplifiers, and then turn off the ECC-1.
XLR configurations
XLR output:
1 = ground 2 = positive 3 = negative
Technical specifications ECC-1
The following technical data were measured on randomised test objects and are typical
data. All measurements are made at 120V / 240V // 50Hz / 60Hz
Measurements
Output impedance 100 ohm
Output level 4,5Vrms
Noise floor (0 dB gain) < -130 dB
Frequency deviation < 0.05 dB
Channel separation > 110 dB
THD + N < 0.002%
Digital/Analogue conversion 24 bit, 192 kHz
Dynamic range 120 dB
Power consumption (no load or signal) 35 W
Dimensions
Width 483 mm
Depth 389 mm
Height 105 mm including feets
Weight 9 kg
Specifications are subject to change without further notice.