Electrocompaniet ECD 2 - Manual (Page 2)

2
ENG
Unpacking the ECD 2
Immediately upon receipt of the ECD 2, inspect the carton for possible dam-
age during shipment. If the carton is visibly damaged, a claim must be filed
with the carrier as soon as possible.
Unpack the unit carefully, and please do remember to save all packaging
materials for future shipment. The carton and packaging have been
designed to offer the safest possible protection when transporting your DAC.
The contents of the carton
• 1 pc. Electrocompaniet ECD 2
• 1 pc. AC power cord
• 1 pc. CD with the Owner's Manual and drivers
• 1 pc. Inspection Card
• 1 pc. Remote control
• 2 pc. batteries
Set up procedure
Before connecting the ECD 2 to the mains, check that the main voltage
indicated on the rear panel corresponds to the line voltage in the terri-
tory where you intend to use the unit.
How to avoid damages
Do not under any circumstances connect or disconnect equipment when
power is turned on. The design of the RCA plug generates a huge tran-
sient when inserted. Connecting or disconnecting equipment with the
power on can result in severe damage to both speakers and amplifier.
How to avoid noise problems
The ECD 2 contains delicate circuits that are sensitive to magnetic stray
fields. The unit should not be placed near main transformers, TV sets,
etc. Care should also betaken regarding placement of the interconnect
cables. Do not run interconnect cables in parallel with main cords or
speaker cables. Keep interconnect cables as short as possible.
How to avoid possible antenna problems
In some set-ups hum may occur when you connect the radio, VCR or TV
to your system. The problem is caused by DC voltage coming from your
antenna. Please contact your cable network operator.