Electrocompaniet ECD1 V1 - Manual (Page 3)

3
Unpacking the ECD 1
Immediately upon receipt of the ECD 1, inspect the carton for possible dam-
age during shipment. The carton and packaging have been designed to prov-
ide the safest possible protection for the transport of your product. Unpack the
unit carefully. Save all packaging materials for future shipment.
The contents of the carton
1 pcs Electrocompaniet ECD 1
1 pcs AC main cord
1 pcs inspection card
Setup procedure
Before connecting the ECD 1 to the mains, check that the mains voltage
indicated on the rear panel corresponds to the line voltage in the territory you
intend to use the unit.
How to avoid damages
Do not under any circumstances connect or disconnect equipment when po-
wer is turned on. The design of the RCA plug generates a huge transient when
inserted. Connecting or disconnecting equipment with the power on can
result in severe damage to both speaker and amplifier.
How to avoid noise problems
The ECD 1 contains delicate circuits that are sensitive to magnetic strayfields.
The unit should not be placed near mains transformers, TV sets etc. Care
should be taken regarding placement of the interconnect cables. Do not run
interconnect cables in parallel with main cords or speaker cables. Keep
interconnect and speaker cables as short as possible.
How to avoid antenna problems
In some set-ups hum may occur when you connect the radio, VCR or TV to your
system. The problem is caused by DC voltage coming from your antenna.
Please contact your cable network operator.