Electrocompaniet EMC1 - Manual (Page 12)

Remote control
1. STANDBY
2. DISC – No function.
3. SCAN – Play 10 seconds of each track.
4. PROG
a. Set the CD player in STOP MODE.
b. Select tracks with the numeric buttons (9), or step to the number using buttons
no. 14 or 15.
c. Press the PROG (4) button – the track is programmed.
Repeat b and c until all the tracks you wish to program is done.
After each track is programmed, the total playtime will be shown in the display.
If a track with number higher than 13 is programmed, the total playtime will not be
shown.
You can browse through the tracks with the buttons 14 and 15. On the tracks that
already are programmed, you will see a “P” shown in the display.
If you wish to remove a track from your program, choose the track number and
press PROG (4).
To monitor what is being programmed. Go back to STOP MODE.
Press PROG (4) – The display will now show the programmed tracks in the new
order.
The tracks are now stored in the order you programmed them and not in the
original numeric order.
If you press STOP (17) two times your program sequence will be erased.
5. FAST – press this button before you use the search buttons (6 or 13). The search
will go faster.
6. SEARCH BACKWARDS
7. A/B – Repeat a segment of the disc/track. Press the button once to mark the start
of the portion to be repeated. Press it again at the end of the desired sequence.
The selected area will play continuously until the STOP (17) button is pressed.
8. SHUF - The tracks will be played in a random order.
9. REP – Press this button once and all the tracks on the disc will be repeated.
The display will show “REPEAT”.
Press the button again, and it will only repeat the current track.
The display will show “REPEAT 1”
10. PAUSE – Pause on/off.
11. NUMERIC CONTROLS – Press these buttons to select a specific track on the disc.
For tracks 10 and above, the second digit of the number must be pressed within
one second.
12. TIME – Press once. In normal operation, the display will show the running time of a
track being played. Press the button once to check the time remaining for the track
in play. Press the button again to view the total playing time of the disc being
played.
13. SEARCH FORWARD
14. NEXT TRACK
15. PREVIOUS TRACK
16. PLAY
17. STOP