Electrocompaniet ECI 5 MKII - Manual (Page 6)

6
Technical specifications ECI 5 MKII:
The following technical data where measured on randomized test objects
and are typical data. All measurements are made at 120V / 240V //
50Hz / 60Hz Clipping point of the amplifier is set to a level where total
harmonic distortion (THD) is 0.2 %.
Preamplifier section
Input impedance (Balanced input)................................... 47 kOhm
Maximum input level .................................................... 10 Vrms
Noise floor (1Vrms, 20 - 20 kHz, balanced).................... -135 dB
THD + N (1Vrms, 20 - 20 kHz, balanced) ...................... <0.003%
Gain (Balanced)............................................................ 0 dB
Amplifier section
Output Impedance ........................................................< 0,02 Ohm
Frequency response (- 3 dB)............................................1 – 150 kHz
Channel separation........................................................> 120 dB
THD + N (20 - 20 kHz).................................................< 0.004%
Maximum peak current...................................................>100A
Damping factor (8 ohm load)..........................................>350
Input sensitivity (120W output)......................................1.3Vrms
Input sensitivity HT (120W output)...................................1Vrms
Rated output power
10 % change in line voltage will give approximately 20 % change in
output power.
8 Ohm2 x 120 W
4 Ohm2 x 200 W
2 Ohm2 x 370 W
Power consumption (no load or signal) 100 W
Standby - 1W
The ECI 5 MKII is DC coupled from input to output.
Dimensions
Width: 483 mm - 19 inch
Depth: 405 mm - 16 inch
Height: 135 mm - 5,3inch
Weight: 20 Kg - 44 lbs
Specifications are subject to change without further notice.
ENG