Electrocompaniet AW60FFT - Manual (Page 7)

Technical Specifications AW 60 FTT:
The following technical data were measured on randomised test objects and are typical data. All
measurements are made with the following equipment:
Distortion analyser: Tektronix AA501
Oscilloscope: Tektronix 468
Oscillator: Tektronix SG505
Frequency counter: Rascal 9838
Phase meter: Hewlett Packard 3575A
Amplifier section
Main voltage 120 V / 240 V. Clipping point of the amplifier is set to a level where total harmonic
distortion (THD) is 0.2 %.
Output Impedance (20 Hz - 20 kHz) < 0,01 Ohm
Nominal input Impedance 330 kOhm
Input sensitivity for rated output single end 0.8V
Input sensitivity for rated output balanced 0.4V
Max. peak current > 60 A
THD (measured at 1 kHz half power, 8 Ohm) < 0,005 %
THD (measured at 1 kHz -1 dB, 8 Ohm) < 0,007 %
Noise (measured with both inputs shorted) < 130 µV
Frequency response DC - 65 kHz
Power bandwidth DC - 100 kHz
Channel separation (1 kHz - 10 kHz) > 90 dB
Rated output power
10 % change in line voltage will give app. 20 % change in output power.
8 Ohm 2 x 60 W
4 Ohm 2 x 110 W
2 Ohm 2 x 150 W
Power consumption (no load or signal) 70 W
Dimensions
Width 483 mm / 19 inches
Depth 380mm / 15 inches
Height 115mm / 4.5 inches
Weight 11Kg / 24.2 lbs.
The manufacturer reserves the right to alter these specifications without further notice.