Electrocompaniet AW60FFT - Manual (Page 4)

Unpacking the amplifier:
Immediately upon receipt of the amplifier, inspect the carton for possible damage during shipment. If
the carton is visibly damaged, a claim must be filed with the carrier as soon as possible.
Unpack the unit carefully, and please do remember to save all packaging materials for future shipment.
The carton and packaging have been designed to offer the safest possible protection when transport-
ing your amplifier.
The content of the carton is as follows:
1 pcs Electrocompaniet Ampliwire 60 FTT
1 pcs AC power cord
1 Owners Manual
1 pcs Spare fuse,
5.0 AT slow-blow 5x20mm (120V AC)
2.5 AT slow-blow 5x20mm (220V AC)
The actual spare fuse is located inside the AC 3 pin receptacle.
Connecting the AW 60 FTT
Connecting to mains
Check that the mains voltage printed on the rear panel of the amplifier corresponds with the line
voltage in the territory were you intend to use your amplifier.
How to avoid damages
A good operating practice is to turn off all equipment before any connections or disconnections are
made. Do not under any circumstances connect or disconnect equipment when power is turned on. If
you insist on connecting or disconnecting while power is turned on, you should be aware that the
design of the RCA plug generates a large transient when inserting the plug. This could damage both
the speakers and the amplifier.
The rear panel
The rear panel of the Ampliwire AW 60 FTT is equipped two single end RCA input sockets, one for
each channel, and two balanced XLR inputs.
Single-ended (normal) input and operation
Upon arrival, the amplifier is set for single-ended use with a shorting plug in the XLR input. This will
short the negative (-) input of the amplifier to ground. With shorting plugs in position, the amplifier is
ready to be connected in a normal way with a single ended preamplifier.