East Coast Supercharging ECS Alky C7 User Manual
Page 17
Step 3
Apply heat to the heat-shrink.
Step4
Slide large heat-shrink over entire connections
Step 5
In the event more than one wire will be attached to the Red wire. Example Map sensor
regulator, use the larger supplied Male spade that can accommodate larger wire and
assemble as stated above.
I mounted the PAC controller up and behind the dash above the hood release cables.
The MAP sensor in my case also was installed there. In my particular case I connected
the hose on the MAP sensor to the plastic tube I ran earlier with the pump cable.