EarthQuake W1265V - Manual (Page 12)

Operator's Manual
Viper® 212cc 4-Cycle Engine
Check for parts online at www.ardisam.com or call 800-345-6007 M-F 8-5 12
MAINTENANCE SCHEDULE
MAINTENANCE ITEM
Every 8 hours
(daily)
Every 50 hours
or monthly
Every 100 hours
or seasonally
Every 300 hours
or yearly
Clean Engine and
Check Bolts and Nuts
X
Engine Oil Check X
(See Lubrication section) Change * (initial 5 hours) X
Oil in Gear Reduction
(if equipped)
Change X
Air Filter Check X X
(See Air Filter section) Clean ** X
Replace X X
Spark Plug (Gap .030”) Check-Adjust X
(See Spark Plug section) Replace X
Fuel Filter Clean *** X
(See Fuel Filter section) Replace
* Perform initial oil change after first 5 hours of operation, then every 50 hours or every season
** Service more frequently under dusty conditions
*** These items should only be performed by a mechanically proficient person or by the servicing dealer
MAINTENANCE AND STORAGE
Please read the maintenance schedule, and observe these
recommended care operating intervals to extend the life of
your engine.
Good maintenance is essential for safe, economical, and trouble-
free operation. It will also help reduce air pollution. To help
you properly care for your engine, the following pages include
a maintenance schedule, routine inspection procedures, and
simple maintenance procedures using basic hand tools. Other
service tasks that are more difficult, or require special tools, are
best handled by professionals and are normally performed by a
technician or other qualified mechanic.
Maintenance, replacement or repair of the emissions control
devices and systems may be performed by any non-road
engine repair establishment or individuals. However, items
must be serviced by an authorized dealer to obtain "no
charge" emissions control service.
The maintenance schedule applies to normal operating
conditions. If you operate your engine under unusual conditions,
such as sustained high-load or high-temperature operation, or
use in unusually wet or dusty conditions, consult your servicing
dealer for recommendations applicable to your individual needs
and use.
CAUTION
TO PREVENT ACCIDENTAL STARTING:
AVOID INJURY! ENGINE MUST BE TURNED OFF AND
COOL AND SPARK PLUG WIRE MUST BE REMOVED
FROM SPARK PLUG BEFORE CHECKING AND ADJUST-
ING ENGINE OR EQUIPMENT.
AVOID INJURY! TEMPERATURE OF MUFFLER AND
NEARBY AREAS MAY EXCEED 150° F (65° C). AVOID
THESE AREAS.
AVOID INJURY! CHECK ENGINE OFTEN FOR LOOSE
NUTS AND BOLTS. KEEP THESE ITEMS TIGHTENED.
WARNING
IMPROPER MAINTENANCE, OR FAILURE TO CORRECT
A PROBLEM BEFORE OPERATION CAN CAUSE A MAL-
FUNCTION IN WHICH YOU CAN BE SERIOUSLY HURT
OR KILLED. ALWAYS FOLLOW THE INSPECTION AND
MAINTENANCE RECOMMENDATIONS AND SCHED-
ULES IN THIS OPERATOR’S MANUAL.