Important, Caution, Unpacking and assembly – EarthQuake 3310V User Manual
Page 6

Check for parts online at
www.getearthquake.com or call 800-345-6007 M-F 8-5
6
Operator's Manual
Front Tine Tiller 3310V
UNPaCkING aND aSSEMBLY
UNPaCkING aND aSSEMBLING YOUR TILLER
1. Open top of carton and remove handlebar assembly.
2. Parts bag for 3310V contains:
2- M8 x 55 screws
2- hand knobs
2- 10 x 50 shaft pins
6- M6 x 12 outer hex flange bolts
6- M6 Locknuts
1-depth regulator lever
3. Cut open top of carton and remove machine:
a.
Assemble top handlebar over lower loop. Put M8 x 55 screws
through both holes from inside out. Put on flat washers 8 and
tighten with hand knobs. SEE FIGURE 1.
b.
Assemble hood extensions using (6) M6 x 12 outer hex flange
bolts plus (6) M6 locknuts. SEE FIGURE 2.
c.
Assemble tines to unit. Sharp edges of tines will be away
from the operator at top or face down at front of machine.
Use (2) 10 x 50 shaft pins plus (2) 2 x 46 B pins. SEE FIGURE 3.
d.
Install wheel assembly to machine using (2) M10 x 25 outer hex
bolts with (2) M10 external toothed lock washers.
SEE FIGURE 4.
INSTaLL DEPTh REGULaTOR LEvER
1. Install the depth regulator lever through hole in bracket from the
bottom up with curve to rear of unit and secure with 4 x 110 B pin.
SEE FIGURE 6 ON PaGE 9.
FILL ENGINE CRaNkCaSE
1. Add oil according to engine manual. Do not overfill. Use a clean,
high quality detergent oil. Container must be marked A.P.I. Service
SF - SJ. Use no special additives with recommended oils. Do not
mix oil with gasoline. Oil level must be full. Check the oil level by
removing oil fill plug. Oil level should be up to the bottom of the fill
plug opening.
2. Always check oil level before starting engine. Refer to engine manual
for capacity and type of oil to use.
Figure 3
IMPORTaNT
ThE RIGhT aND LEFT SIDES OF YOUR RO-
TOTILLER aRE DETERMINED FROM ThE
OPERaTING POSITION aS YOU FaCE ThE
DIRECTION OF FORWaRD TRavEL.
ENGINE IS ShIPPED FROM FaCTORY WITh-
OUT OIL. YOU MUST aDD ENGINE OIL BE-
FORE STaRTING ENGINE.
CaUTION
DO NOT TRY TO LIFT ThE ROTOTILLER FROM ThE
CaRTON.
Figure 1
Figure 2
Figure 4