EarthQuake W2265V - Manual (Page 3)

ARDISAM
.com
Earthquake, Division of Ardisam, Inc. Page 3
800-345-6007
ASSEMBLY INSTRUCTIONS AND PARTS ExPLOSIONS
Log Splitter Models
REPAIR AND MAINTENANCE SAfETY:
• Do not operate your log splitter in poor mechanical condition or
when in need of repair.
• Periodically check that all nuts, bolts, and screws are tightened.
• Always perform recommended maintenance procedures before
using your log splitter.
• Do not alter your log splitter in any manner such as attaching a
rope or extension to the control lever or adding to the width or
height of the wedge.
• Replace all damaged or worn parts immediately.
• Never tamper with the engine in order to operate at excessive
speeds. The maximum engine speed is preset by the manufac-
turer.
• Do not service or repair your log splitter without removing the
spark plug wire.
• All replacement parts must meet manufacturer’s specifications.
TOWING SAfETY:
• Obey all federal, state and local regulations when towing on
public roads and highways.
• Before towing, be certain that your log splitter is correctly and
securely attached to the towing vehicle and that a safety chain is
in place.
• Never carry any cargo or wood on your log splitter. Do not allow
anyone to sit or ride on your log splitter.
• Before using your log splitter, disconnect it from the towing
vehicle.
• When turning, parking, crossing an intersection, and driving in all
situations allow for added length of your log splitter.
• Be careful when backing up.
• Adjust towing speed for terrain and conditions.
• Never operate your log splitter under the influence of alcohol,
drugs or medication. A clear mind is essential for safety.
• Maximum speed of 45 mph is recommended when towing log
splitter.
fIRE PREVENTION:
• Never operate your log splitter near a flame or spark. Hydraulic
oil and gasoline are flammable and can explode.
• Do not fill the gas tank while the engine is hot or running. Allow
the engine to cool before refueling.
• Never smoke while operating or refueling your log splitter. Gas
fumes can easily explode.
• Only refuel your log splitter outdoors in a clear area. Always use
an approved fuel container. Always replace the gas cap securely.
• If gas is spilled, move machine away from the area of the spill
and avoid creating any source of ignition until the spilled gas has
evaporated or been cleaned up.
• Keep a Class B fire extinguisher nearby when operating your log
splitter in dry areas as a precautionary measure against possible
flying sparks.
• Completely drain the fuel tank prior to storage. Do not siphon by
mouth.
• Always store gasoline in an approved, tightly sealed container.
Store the container in a cool, dry place. Do not store indoors or
near a heating appliance.
HYDRAULIC SAfETY:
• The hydraulic system and mechanical parts of your log split-
ter require careful inspection. Be sure to replace any damaged
hydraulic component.
• Fluid escaping from a very small hole can be very difficult to see.
Do not check for leaks with your hand. Escaping fluid under pres-
sure can have sufficient force to penetrate skin, causing serious
personal injury or even death. Leaks can be located by passing
a piece of cardboard or wood over the suspected leak. Look for
discoloration.
• If injured by escaping fluid, see a doctor at once. Serious infec-
tion or reaction can develop if proper medical treatment is not
administered immediately.
• Should it become necessary to loosen or remove any hydraulic
fitting or line, be sure to relieve all pressure by shutting off the
engine and moving the control handle back and forth several
times.
• The pressure relief valve on your log splitter is preset at the fac-
tory. Do not adjust the valve. Only a qualified service technician
should perform this adjustment.