EarthQuake 9060300 - Manual (Page 9)

Operator’s Manual
Viper® 196cc 4-Cycle Engine
Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5 9
CHECkING aND aDDING OIl
Be sure the engine is located on a level surface before checking
or refilling oil.
1. Clean around oil fill area and drain plug. SEE FIGURE 1.
2. Slide out dipstick and wipe clean with cloth. SEE FIGURE 1.
3. Reinsert and tighten dipstick.
4. Slide out dipstick and check oil.
5. If oil level is below the top thread of the oil fill hole, refill to
upper level. SEE FIGURE 1.
6. Change oil if contaminated.
Viper® engine oil may be put in through the oil dipstick hole or
through the oil fill plug opening. If an oil plug is present, loosen
screw and fill oil until oil level is even with top thread in plug hole.
CHECkING aND FIllING FUEl TaNk
Be sure the engine is located on a level surface before checking
or refilling fuel. Use unleaded regular, unleaded premium
automotive fuels only. Commercial fuel may contain up to
10% ethanol. Ethanol additives to fuel are known to cause
deterioration of fuel lines and other fuel components. Viper®
recommends the addition of fuel stabilizer to protect your
engine’s fuel system and prolong the life of your engine. DO
NOT mix oil with fuel.
1. Make sure engine is cool and not running while filling.
2. Remove fuel cap.
3. Fill tank to fuel level limit. SEE FIGURE 2.
Note: Do not overfill.
3. Replace cap and remove any spilled fuel before operating.
WaRNING
FUEl IS HIGHlY FlammaBlE aND mUST BE HaNDlED
WITH CaRE. NEVER FIll THE TaNk WHEN THE ENGINE
IS HOT OR RUNNING. alWaYS mOVE OUTDOORS TO
FIll THE TaNk.
upper level
lower level
Figure 1
oil fill area/
dipstick
oil drain
plug
Figure 2
A
A
SECTION A-A
SCALE 1 : 5
B
DETAIL B
SCALE 1 : 3
PARTS TO BE FREE OF
BURRS AND SHARP EDGES
THIS DRAWING AND ALL INFORMATION CONTAINED HEREIN IS AND REMAINS THE PROPERTY OF ARDISAM INC.
AND IS CONFIDENTIAL. IT IS SUBMITTED AND MAY BE USED ONLY IN CONNECTION WITH ARDISAMS' PROPOSALS
AND/OR ITS CUSTOMERS' ORDERS. IT SHALL NOT BE DISCLOSED TO OTHERS OR COPIED WITHOUT ARDISAMS'
SPECIFIC WRITTEN CONSENT AND SHALL BE IMMEDIATELY RETURNED UPON REQUEST.
MATERIAL NAME
TREATMENT
DR BY APPD PRT NO 92000
PT WEIGHT SURFACE AREA DATE REVISION
THIRD ANGLE PROJECTION
SEE BILL OF MATERIALS
NONE
8153 1776531
ENGINE 196CC XINGYUE
HORIZ THREADED M16X1.5
3
LAR RJR 8/22/11
7/28/2011 SHEET: 1 OF 1 ALL ANGLES ARE DECIMAL DEGREES
UNLESS OTHERWISE SPECIFIED
DIMENSIONS ARE IN MILLIMETERS
THREADS CLASS 2
0.0 ± 1.0°
0 ± 2°
ANGLES:
0.000 ± 0.250 MM
0.00 ± 0.75 MM
0.0 ± 2.5 MM
OTHERWISE NOTED:
TOLERANCE UNLESS
fuel level limit