Digiframe DF-SCWF08w - Manual (Page 12)

12
Connect to Wireless Network (WiFi Mode)
You can make a direct wireless connection between the
Scanner and your device in following steps.
1. Press and hold the /SCAN button for 3 seconds
until the power LED emits green light.
* Wait about 20 seconds until the LED blinks blue light.
2. Enable the WiFi mode on your device, search the
“DIRECT-xxxxxx_iScanAirGo” network for the
Scanner, then select it.
* The "xxxxxx" in the network name is a 6-digit code randomly
assigned for your Scanner.
3. Input 8-digit password “ 12345678 ” to connect
the Scanner.
* The LED will stop blinking and become a solid blue light
after connected.
Connected Wi-Fi On
• Be sure the Scanner is used within approximately 60 feet
~100 feet (18m~30m) from your WiFi enabled device in
an obstacle free indoor environment.
• The Scanner will automatically shut down if there is no
operation for 5 minutes for saving power.
• The Scanner allows connection up to 8 mobile devices at
once.
• To turn power off, press /SCAN button for 4 seconds
until the Power LED indicator turns off.
NOTES
ON