Deltech Fitness DF9500- Flat/Incline/Decline Bench - Manual (Page 6)

(NOTE: THE NUTS USED ON THIS BENCH ARE LOCK NUTS, THIS MEANS YOU MUST TIGHTEN THEM DOWN
PAST THE PLASTIC INSERT.)
INSTALL THE SLIDE ASSEMBLY ONTO THE FRAME (G).
ATTACH THE REAR FOOT (C) TO THE FRAME (G) USING THE M10 x 25MM BOLTS (U) AND
THE M10 FLAT WASHERS (W). THEN SLIDE THE RUBBER BOOTS (P) ONTO THE REAR FOOT
(C).
NOW ATTACH THE FRONT FOOT (B) TO THE FRAME ASSEMBLY (G) USING THE M12 x
76MM BOLTS (T), THE M12 FLAT WASHERS (V) AND THE M12 LOCK NUTS (X). THEN SLIDE
THE THE RUBBER BOOTS (P) ON THE FRONT FOOT (B).
FRAME ASSEMBLY
T
P
B
P
V
V
G
P
P
C
U
W
W
SLIDE ASSEMBLY
U
X