14 motion set – Q-See QSD004C4-250 User Manual
Page 14
- 11 -
QSD004C4-250 User’s Manual
5.14 Motion Set
SENSITIVITY:
Use [ Up] and [ Down] button to select
the channel you want to modify, press
[ SEL] to adjust sensitivity of motion
detection on each channel.
High (1----------9, OFF) Low
When it’s “OFF”, the channel cannot be
triggered by motion.
MOTION RECORD TIME:
This number indicates how many seconds
the motion detection recording continues
after a motion triggered event ends.
MOTION ALARM TIME:
This number indicates how many seconds
the buzzer inside the DVR will sound
after the DVR has been triggered by
motion.
CONT: Continuous alarm until any key is
pressed to stop.
OFF: No alarm
MOTION SET:
MOTION SET
MOTION RECORD TIME: 10
MOTION ALARM TIME: OFF
MOTION SET
PRESS (UP, DOWN), ENTER (SELECT)
PRESS (MENU) TO EXIT
MOTION DETECTION SET
>CHANNEL 1 SENSITIVITY 4
CHANNEL 2 SENSITIVITY 4
CHANNEL 3 SENSITIVITY 4
CHANNEL 4 SENSITIVITY 4
CHANNEL 1 AREA SET
CHANNEL 2 AREA SET
CHANNEL 3 AREA SET
CHANNEL 4 AREA SET
PRESS (UP, DOWN), ENTER (SELECT)
PRESS (MENU) TO EXIT
AREA SET:
Use [ Up] and [ Down] buttons to select the channel you want to modify,
press [ SEL] button to enter the sensitive area of each camera. The picture of the
selected channel is divided into 144(12*12) blocks, press [REW] to move left,
press [FWD] to move right, press[ Up] and [ Down] to move the cursor up and
down, press [ SEL] to set the block active or not.
When the block is transparent, it’s active to record. When the block is covered
by shadow, it is not active, and motion in this area will NOT be detected.
Make sure Record Schedule is set to Motion for the times required.