Danby DPF074B1WDB - Manual (Page 9)

DOOR REVERSAL INSTRUCTIONS
Unscrew
Screw
Screw
screw
Unscrew and remove the bottom hinge pin. 9
Turn the bracket over and replace the hinge
pin.
Re-attach the bottom hinge bracket on the left 10
side. Re-attach both adjustable feet. Re-attach the
lower door in the proper position, by fitting it on the
hinge.
Rotate the middle hinge by 180° and line it up on 11
the left side in the appropriate position. Place the
middle hinge pin into the upper hole of the lower
door, and then tighten the bolts.
Ensure the freezer door is aligned horizontally and •
vertically, so that the seals are closed on all sides
before finally tightening the hinge.
Re-attach the upper door. Ensure that the door is 12
aligned horizontally and vertically so that the seals
are closed on all sides before finally tightening the
upper hinge.
Insert the upper hinge bracket and screw it to the 13
top of the unit.
Use a spanner to tighten it if necessary. 14
Re-attach the top cover and then re-attach the 15
screws which hold it in place.
With the doors closed, check that the doors are 16
aligned horizontally and vertically, and that the
seals are closed on all sides before finally tighten-
ing the bottom hinge. Re-adjust the leveling feet as
needed.
7