Da-Lite Dual Format Imager - Manual (Page 4)

4
3. Assemble left side of frame to the top of frame. The large
black metal L bracket will slide into the aluminum extrusion
while the small L bracket will slide into the aluminum channel.
The pin end bracket needs to be on the outer surface to bolt
into the rivnuts of the left side piece. The slat will need to be
guided in between the standing fin and the front of the frame.
4. Using a 5/64" allen wrench, tighten set screws in frame
straightner bracket. Adjust set screw so that the front surfaces
evenly match at the corner (Figure 4).
5. Using a 1/8" allen wrench, insert (3) #10 x .375" long button head
screws in frame corner connector bracket. Tighten down snug to
frame surface (Figure 5).
Frame Assembly (continued)
Figure 2 – Back of Frame Figure 3 – Back of Frame
Figure 5
Guide slat in
front of fin
Loosen set
screws for
clearence
before
inserting
side pieces.
Figure 4 – Back of Frame
Set Screws
Fasten pin
end bracket
(2) #10 x .500"
Button
Head
Screws