Directed Electronics s680 User Manual

Page 8

against the panel and mark the two
holes at the rear of the housing.

3. Drill the smaller center hole using a

1/8" drill bit. This is the mounting
screw hole.

4. Drill the larger off-center hole using a

3/8" drill bit, insert a grommet and
route the speaker wire from the
crossover through the grommet.

5. After removing the surface mount

tweeter assembly trim ring, route
the tweeter wires through the larger
hole in the housing and connect to
the speaker wires from the
crossover. (See Figure 5.)

6. Insert the excess speaker wire into

the hole and position the housing so
the housing will not pinch the wires
after final mounting.

7. Attach the housing using the

supplied screws of the correct length
for a solid mount.

8. Insert the tweeter into the housing

and attach the trim ring.

Removing Trim Rings

Hold the tweeter housing while gently
turning the trim ring in a clockwise direc-
tion until it releases. The trim ring can
then be easily lifted away from the
tweeter housing.

Installing Trim Rings

FFlluusshh M

Moouunntt AAsssseem

mbbllyy - With the

arrow in the tweeter housing facing
up, place the trim ring into the
housing with the Directed logo at the
bottom and turn in a counter clock-
wise direction until the trim ring
clicks into place.

SSuurrffaaccee M

Moouunntt AAsssseem

mbbllyy - Insert the

trim ring into the housing and turn in
a counter clockwise direction until
the trim ring clicks into place.

DRW-12

FLUSH MOUNT

TWEETER

ASSEMBLY

PRESSURE

RING

WIRING HARNESS

TWEETER WIRE

FIGURE 2—FLUSH MOUNTING REMOVED PANELS