Da-Lite ViewShare Tensioned Advantage Retrofit - Manual (Page 5)

5
Transfer of Existing Motor
1. Once the old screen and roller assembly is out of the case,
remove the Phillips head screw securing the screen tensioning
cable to the roller on the motor end (Figure 9).
2. Remove motor from the old screen and roller assembly and set
aside (Figure 10).
NOTE: Try to avoid turning the rubber collar on the motor as you
are pulling the motor out of the roller as this will change the limit
switch settings.
3. Remove the black L-bracket from pin end of roller (Figure 11).
4. Unscrew shipping brackets from slat and gently lay slat behind
roller (Figure 11).
Figure 10
Figure 9
Motor
Roller
Assembly
Phillips Head
Screw
Screen
Tensioning
Cable
Figure 11
Black
L-Bracket
Shipping
Bracket