Da-Lite Designer Contour Electrol - Manual (Page 3)

3
Installation
Carefully unpack screen and remove outer wrapping from case.
Remove the black tape from the slat bar after the case has been installed.
There are three ways to install the Designer Contour Electrol: Wall Mount,
Ceiling Mount, or Ceiling Hook. Procedures for each method are as follows:
Wall Mount
1. Secure the wall mount bracket to the wall at the desired
height. Bracket should be fastened to wall studs or some
reinforcement within the wall. Concrete or brick walls require
special fasteners and anchors.
2. Make sure the bracket is level. See figure 1 for reference
dimensions.
3. Keep in mind you will need at least 5/8" between the ceiling
and the top of the wall mount bracket to be able to position
the case on the bracket.
4. Mount the screen case on the wall bracket as shown in figure 1.
Be sure the case is fully seated on the bracket. Tighten the
stop screws against the wall bracket.
Ceiling Mount
1. Do not remove the wall mount bracket, even if you are not
using it for mounting. This provides structural stability to
the case.
2. Be sure the ceiling has adequate reinforcement to attach the
screen brackets.
3. The top of the screen case has a channel that the ceiling
mount brackets slide into. Remove the end cap on the right
end of the case and insert the brackets into the case channel.
Lock the brackets in place by tightening two set screws. Refer
to figure 2. Mount cannot be more than 12" from end of case.
4. Hold the screen case up to the ceiling and mark the hole
locations. Drill holes into the ceiling and attach screen with
the appropriate fasteners for your ceiling.
Ceiling Hook
1. Do not remove the wall mount bracket, even if you are not
using it for mounting. This provides structural stability to
the case.
2. Be sure the ceiling has adequate reinforcement to attach
a hook anchor.
3. The top of the screen case has a channel that the ceiling
hook brackets slide into. Remove the end cap on the right
end of the case and insert the brackets into the case channel.
Lock the brackets in place by tightening two set screws.
Refer to figure 3.
4. The brackets can be attached anywhere within 12" of the end
of the case.
5. Attach an S-hook or similar fastener to the large center hole
on the bracket.
Figure 1
Figure 2
5/16"
9/16"
Case Hook
Set Screws (2)
Ceiling
Mount Holes
Endcap
Endcap
Screws (3)
Wall Mount
Bracket
4 1/4"
4 5/8"
Stop Screw
Figure 3
Set Screws (2)
Hook Mount
Hole
Endcap
Endcap
Screws (3)