Connerton Model A-4F - Manual (Page 12)

The Connerton Company warrants to the original user for a period of one year from date of installation, not to
exceed 18 months from date of shipment by Connerton, that the equipment manufactured is free from defects
in material or workmanship.
Our obligation under this warranty shall be limited to furnishing without charge any part of said product which,
upon examination by The Connerton Company shall prove to be defective. Parts wear is not considered a
defect. The Connerton Company will not be responsible for labor or transportation charges incidental to the
replacement of same.
The Connerton Company assumes no responsibility for failure of the equipment to operate properly due to
improper installation or operation. This warranty applies to all equipment that has been unaltered, properly
installed and maintained in accordance with national and local codes and in accordance with the installation
and operating instructions included with this equipment.
This warranty does not extend to normal maintenance items, including but not limited to, thermostatic
calibrations, air and gas adjustments and adjustments to pilot flames. Proper installation, adjustments,
calibration and initial checkout is the responsibility of the dealer, the owner-user or installer and not that of The
Connerton Company.
Exceptions to warranty:
1) Flexible gas connectors that are bent or twisted due to improper installation or operation and/or modifying
the location of fittings that the tube is connected to.
LIMITED WARRANTY
Please fill out and refer to the following when contacting the factory:
Model # A-4F Serial# Gas Type: Purchase Date:
TROUBLESHOOTING GUIDE (cont.)
Bottom drawer hard to Spring tension too tight Loosen spring adjustment rod until
Push to down position drawer can be pushed down with one
finger.
Top griddle not level Broiler has not been Adjust bullet feet inserts until broiler
setup properly. is level from side to side, and from
front to rear.
Condition Probable Cause Solution
Bottom drawer does not Detent setup Clean detent plate depressions, ball
remain in middle positions bearings and springs. Replace with
new parts if necessary.
Bottom griddle not level Leveling rod setting Adjust left and right side rods evenly,
top nut first then bottom nut, until
pitch drops 1/8” in rear.