Coda FET Phono Preamplifier 06X - Manual (Page 6)

INSTALLATION 6
2. In order to set the input loading you must toggle the dIP switches which are located
on the main board of the preamplifier. each one of these switches connects a resistor
or capacitor in parallel with the input and so adjusts the load value. The default values
are 47kΩ and 50pF. refer to the diagram below, which is repeated inside the unit, to
determine the values which need to be switched in for your cartridge. replace the cover
after setting the switches.
3. The balanced outputs are equipped with switchable phase due to differences in usa/
european standards. The default setting is european but may be changed according to
the following diagram. These switches can also be used to select absolute phase.
4. althoug the 06x is generally resistant to electromagnetic interference it is recom-
mended that the unit not be installed near any sources of strong electromagnetic fields.
5. Before installing the preamplifier make sure all of the power switches of any associated
components are switched off. If any of your other audio components do not have power
switches, make sure they are unplugged from their aC power source.
NOTE: The lINe volTage oF The PreaMPlIFIer 06x Is swITChaBle To PerMIT use IN dIF-
FereNT CouNTrIes. CoNTaCT Coda TeChNologIes For INsTruCTIoNs oN ChaNgINg
The oPeraTINg volTage.
XLR BOARD XLR BOARD
T H G I R T F E L
BALANCED OUTPUT
T H G I R T F E L
BALANCED OUTPUT
+
+
_ _
+
_
+
_ 1
2
3
1
2 3 1
2
3
1
2 3 1
2
3
1
2 3
USA European
4 DETAILED INSTALLATION
22 22
47 47
100 100
1000 1000
1000 PF 1000 PF
200 PF 200 PF
100 PF 100 PF
50 PF 50 PF
ON ON