Directed Electronics G4203P - Manual (Page 8)

8 © 2008 Directed Electronics. All rights reserved.
➢
Battery Replacement
Front
Elastomer
contact
Front
Elastomer
contact
Front
Elastomer
contact
+ + +
Circuit Board
Front
Elastomer
contact
Front
Elastomer
contact
Front
Elastomer
contact
+ + +
Circuit Board
Using a small slotted screw- 1.
driver, insert into slot located on
the side of the unit as shown and
carefully pry the front of the unit
up, working your way around the
edge until the front is complete-
ly separated from the housing.
Note:
Make sure that the small elas-
tomer contact located inside the unit
as shown does not fall out during the
replacement process.
Turn the circuit board over, re- 2.
move batteries from clip and replace.
Note:
Verify that the battery polarity is correct when replac-
ing. Batteries are stacked in series and polarity is indicated.
Reposition all parts and snap together. 3.
Front
Elastomer
contact
Front
Elastomer
contact
Front
Elastomer
contact
+ + +
Circuit Board