Valet take-over – Directed Electronics G4203P User Manual

Page 12

➢

Valet Take-Over

The Valet Take-Over feature allows the vehicle to remain running
after the key has been removed from the ignition. This feature is
useful for occasions when you wish to exit and lock the vehicle for
short periods of time, but would like to leave the motor running
and the climate controls on.

To perform Valet Take-Over:

Before turning off the engine, press and release the single button

once. The remote responds with the remote start ON tones and the
green LED on the remote flashes once. The vehicles parking lights
turn on constant to confirm remote start operation.
Turn the ignition key to the OFF position.

(The engine stays running.)

The engine runs until pre-programmed time elaps-

es or a shut-down input is received. (See the pre-
vious Remote Start section for a complete list of
shut-down inputs.)

Note:

This feature does not work if the brake pedal is being pressed.