Clay Paky SHARPY WASH 330 PC - Manual (Page 29)

29 SHARPY WASH 330 & PC
172
(6.77")
63
(2.48")
405
(15.94")
330
(12.99")
520
(20.47")
205
(8.07")
465
(18.30")
320
(12.60")
390
(15.35")
Top Hat IN
345
(13.58")
490
(19.29")
Top Hat OUT
Power supplies available
115/230V 50/60Hz
Input power:
520VA a 230V 50Hz.
Total output
Sharpy Wash 330 - Max 17300 lumens
Sharpy Wash 330 PC - Max 18200 lumens
Lamp:
Lamp system with a short arc burner in a reflector
• Type Philips MSD Platinum 16R (LAM00E)
- Output Lamp power: 330W
- Colour temperature 8000 K
- Average life 1500 h
- Any working position
- Luminous flux rated: 16000 lumens
Motors:
14 stepper motors, operating with microsteps,
totally microprocessor controlled.
Channels:
Max 22 control channels.
Inputs:
DMX 512
Ethernet
Moving head:
• Movement by means of two stepper motors,
controlled by microprocessor.
• Automatic repositioning of PAN and TILT after
accidental movement not controlled by control
unit.
• Angle:
- PAN = 540°
- TILT = 240°
• Resolution:
- PAN = 2.11°
- PAN FINE = 0.008°
- TILT = 0.98°
- TILT FINE = 0.004°
IP20 protection rating:
• Protected against the entry of solid bodies larger
than 12mm (0.47”).
• No protection against the entry of liquids.
CE Marking:
Complies with the following European Directives
- 2006/95/EC (LVD)
- 2004/108/EC (EMC)
- 2011/65/EU (RoHS).
Safety Devices:
• Bipolar circuit breaker with thermal protection.
• Automatic break in power supply in case of
overheating or failed operation of cooling system.
Cooling:
Forced ventilation with axial fans.
Body:
• Aluminium structure with die-cast plastic cover.
• Two side handles for transportation.
• Device locking PAN and TILT mechanisms for
transportation and maintenance.
Working position
Working in any position.
Weight:
Sharpy Wash 330: 18.5Kg (40lbs 11ozs)
Sharpy Wash 330 PC: 20.5Kg (45lbs 2ozs)
TECHNICAL INFORMATION
CAUSE AND SOLUTION OF PROBLEMS
THE PROJECTOR WILL NOT SWITCH ON
PROBLEMS
ELECTRONICS NON-OPERATIONAL
DEFECTIVE PROJECTION
REDUCED LUMINOSITY
POSSIBLE CAUSES CHECKS AND REMEDIES
No mains supply.
Lamp exhausted or defective.
Signal transmission cable faulty or disconnected.
Incorrect addressing.
Fault in the electronic circuits.
Lenses or reflector broken
Dust or grease deposited.
Check the power supply voltage.
Replace the lamp. (See instructions).
Replace the cables.
Check addresses (see instructions).
Call an authorised technician.
Call an authorised technician.
Clean (see instructions).