Clay Paky SHARPY WASH 330 PC - Manual (Page 22)

22 SHARPY WASH 330 & PC
LAMP
Used for turning lamp on and off from the projector control panel.
1) Press
F - the current settings appear on the display (On or Off).
2) Use the UP B and DOWN C keys to turn the lamp on (On) or off (Off)
3) Press F to confirm the selection or LEFT D to keep current settings
and return to the top level.
RESET
Used for resetting the projector.
1) Press
F to reset the projectors, a confirmation message (Are you sure
?) appears on the display.
2) Select YES to starting reset the fixture or NO to keep the current setting
and return to the top menu level.
CHANNEL
Used for setting channel levels from the projector control panel.
1) Press
F - the first channel appears on the display.
2) Use the UP B and DOWN C keys to select the required channel:
3) Press F and use the UP B and DOWN C keys to select the
required DMX level (value between 0 and 255).
4) Press LEFT D to return to the top menu level.
MANUAL CONTROL
No
Yes
Reset
Channel
Test
Pan-Tilt
Colour
Beam
All
TEST
Allows you to check the proper functioning of effects.
1) Press
F to return to the top menu level.
2) Use the UP B and DOWN C keys to select the required test.
3) Press F to confirm the selection or LEFT D to keep current settings.
Test sequence:
Pan - Tilt effects (Pan & Tilt)
Colour effects (Colour wheel - CMY )
Beam effects (Stopper-Strobe / Dimmer / Beam shaper / Zoom / Frost)
All effects
TEST MENU
To enable the "Advanced Menu" set up the "Access code" (1234) using the
UP
B , DOWN C , RIGHT E keys.
Press F - "Menu advanced" appears on the display
UP LOAD FIRMWARE
Allows you to transfer the firmware from 1 fixture to all the connected fixtures.
1) Press
F , a confirmation message appears on the display.
2) Select YES to start the firmware loading or NO to keep the current set-
ting and return to the top menu level
SETUP MODEL
Allows you to change the default model of projector.
1) Press
F a confirmation message appears on the display.
2) Select YES to define the model of projector or NO to keep the current
setting and return to the top menu level.
CALIBRATION
Allows you to adjust effects from the control panel to obtain perfect unifor-
mity between the projectors.
1) Press
F - “channels” appears on the display.
2) Using the UP B and DOWN C keys, select the effect you wish to
regulate.
3) Press F and use the RIGHT E , UP B and DOWN C buttons to
make the adjustment by setting a value between 0 and 255.
4) Press F to confirm the selection or LEFT D to keep current set-
tings and return to the top level.
FACTORY DEFAULT
Allows you to restore default values of all channels (128).
1) Press
F – a confirmation message appears on the display (Reset
calibration to factory default ?).
2) Select YES to reset calibration to factory default or NO to keep the
current setting and return to the top menu level.
ADVANCED MENU
Advanced
Code
1234
Calibration
Upload
Firmware
Transfer the firmware on all
the connected fixtures ?
Are you sure ?
Yes/No
Setup
Model
Changing to a wrong model
may damage the fixture.
Are you sure ?
Yes/No
Lamp
Manual
Control
On
Off