Floppy driver, Ide devices, Advanced – Chicago Gaming Nicktoons Racing User Manual
Page 19: Chipset configuration, Resource configuration, Peripheral configuration, System hardware monitor, Security
“system date” = {set the current date}
“system time” = {set the current time}
8.1.1.1. Floppy Driver
Floppy Drive A = Not installed
Floppy Drive B = Not installed
Floppy Drive Swap = Disabled
Floppy Driver Seek = Disabled
8.1.1.2. IDE Devices
Primary IDE Master = {your C: drives name, i.e. Maxtor 2F020L0}
Type = Auto
32 Bit transfer = OFF
Ultra DMA = Disable
Primary IDE Slave = Not Installed
Secondary IDE Master = {your CD drive, i.e. GCR-8523B}
Secondary IDE Slave = Not installed
PCI IDE BusMaster = Enabled
S.M.A.R.T. for Hard disks = Enabled
Spread Spectrum = Disabled or Enabled
8.1.2. Advanced
CPU Host Frequency = By Jumper
SDRAM Frequency 133Mhz
8.1.2.1. Chipset Configuration
PCI Delay Transaction = Disabled
OnChip VGA Frame Buffer Size = 16MB
USB controller = Enabled
USB Device Legacy Support = Enabled
SDRAM CAS Latency = Auto
8.1.2.2. Resource Configuration
PCI Latency Timer (PCI clocks) = 32
8.1.2.3. Peripheral Configuration
OnBoard FDC = Auto or Disabled
OnBoard Serial Port = Auto or 3F8/COM1
OnBoard Infrared port = Disabled
OnBoard Parallel port = Auto or 378
Parallel Port Mode = EPP+ECP
EPP Version = 1.9
Parallel port IRQ = 7
Parallel Port DMA Channel = 3
OnBoard Midi Port = Enabled
MIDI Port I/O address = 330h-333h
OnBoard Game Port = Enabled
OnBoard IDE = Both
OnBoard LAN = Enabled
OnBoard AC’97 Audio = Auto
OnBoard MC’97 Modem = Disabled
8.1.2.4. System Hardware Monitor
(Nothing is settable here)
(Read only) Supervisor Password Is = Clear
8.1.3. Security
(Read only) User password Is = Clear
Set Supervisor Password = [Enter] {Do not set a password!}
Password Check = Setup
Copyright © Chicago Gaming Company
Page 19