Chicago Gaming Ultimate Arcade - Manual (Page 3)

1.4 ATARI END USER LICENSE AGREEMENT
By accepting and operating an Ultimate Arcade, the owner (“End User”) of the unit
agrees to abide by the terms of this agreement. Asteroids, Asteroids Deluxe, Battlezone,
Black Widow, Centipede, Crystal Castles, Gravitar, Liberator, Lunar Lander, Major
Havoc, Millipede, Missile Command, Red Baron, Space Duel, Super Break-Out,
Tempest, Warlords and related logos are used under license from Atari Interactive, Inc.
(“Atari”). Atari expressly reserves the sole and exclusive ownership of the
aforementioned games and all rights relating thereto. The end user hereby acknowledges
that Atari is the sole and exclusive owner of the games and licensed trademarks and
agrees not to challenge at any time, directly or indirectly, the rights of Atari. The end
user agrees not to attempt to copy the licensed property (in whole or in part), decompile,
disassemble or otherwise reverse engineer the software in any way. Atari is a third party
beneficiary to this agreement and retains the right to bring action directly against an End
User for breach of this End User License Agreement.
1.5 WARRANTY INFORMATION
Ultimate Arcade is warranted against manufacturing defects for 90 days. After that we
will provide free telephone support. If at some point you require warranty service,
contact Chicago Gaming at (708)780-0070. Ask for technical support.
2. GAME SETUP
2.1 PRE-GAME INSTALLATION
Remove the game from the shipping container. Included with the game; is an envelope
containing the game keys, SYSTEM RECOVERY CD, and this manual. The Ultimate
Arcade is pre-configured from the factory for immediate play so no software installation
is necessary. Connect the wall cord to a grounded (3-terminal) AC wall outlet. The
following precautions should be followed when installing the game:
• Avoid rough handling of the game; the picture tube is fragile.
• Install the game on a level surface.
• Avoid installing the game where it will receive excessive sunlight or heat,
to protect the game from rising internal temperatures.
• Do not install in a damp or dusty location.
• For a short time after connecting the power to the game, the picture may
be temporarily distorted.
The monitor’s purity is affected by the Earth’s magnetic field, causing a variation
of color. By turning the game on for 10 or 15 seconds and then off for 20 or 30 minutes
the automatic degaussing circuit applies a degaussing field around the edges of the
monitor. Doing this a number of times will correct the problem.
Another way to correct the problem is to purchase a degaussing coil or bulk tape
eraser at any electronics store. This will help to immediately demagnetize the video tube.
Caution must be used with a degaussing coil so that the magnetic field of the degaussing
coil is not allowed to become too intense at any one place on the picture tube, thereby
causing a localized color distortion.
Primary monitor adjustments are located behind the faux coin door.
2.2 ON / OFF SWITCH
The On/Off switch is located on the top of the machine in the back right
hand corner.
3