Directed Electronics Automate 552 User Manual

Page 33

Key. Turn the ignition on and then back off.

Select Menu. Press and hold the Valet®/Program switch until either the LED flashes once

and the horn honks once to select Menu One, or the LED flashes twice and the horn honks

twice to select Menu Two.

Choose. Within 10 seconds, press and release the Valet®/Program switch the number of

times corresponding to the feature number you want to program. (See Feature Menus.)

Once the Valet®/Program switch has been pressed and released the correct number of times, press it once more

and hold it. After a second, the LED will flash to indicate which feature you have accessed. For example, in Menu

Two, groups of eight flashes would indicate access to the status output feature. The horn will also honk eight

times (if connected).

Transmit. The transmitter is used to select the desired setting. As shipped, the unit is con-

figured to the LED ON settings. These are the default settings. Pressing Channel 1 (usually

Button I) will set it to the LED ON setting. The LED will light solid (stop flashing) to indi-

cate the setting. The horn will honk once (if connected). Pressing Channel 2 (usually

Button II) will change the setting to the LED OFF setting. The LED will go out indicating

the change and the horn will honk twice (if connected).

Release. The Valet®/Program switch can now be released.

For example, to program the arming mode from active to passive, within 10 seconds of turning the ignition off,

select Menu One and press and release the Valet®/Program switch once. Then press it again and hold it. The LED

will flash in groups of one and the horn will honk once (if connected). While holding the Valet®/Program switch,

press the Channel 2 transmitter button. The LED will stop flashing and go out. The horn will honk twice if con-

nected. Passive arming is now programmed. If that was not the desired setting, without releasing the

Valet®/Program switch, press the Channel 1 button on the transmitter. The LED will light solid and the horn will

honk once if connected. Active arming is now programmed. Release the Valet®/Program switch after the desired

selection is made.

You can advance from feature to feature by pressing and releasing the Valet®/Program switch the number of times

necessary to get from the feature you just programmed to the feature you wish to access. For example, in Menu

One, if you just programmed the arm/disarm chirps (Feature 1-2) and you next want to program ignition con-

trolled door locks (Feature 1-3) to off, release the Valet®/Program switch. Press and release it once to advance

from Feature 1-2 to Feature 1-3. Then press it once more and hold it. The LED will flash in groups of 3 and the

horn will honk 3 times (if connected) to confirm that you have accessed Feature 1-3.

to program the learn routine