Bonaire 5 Star Silhouette - Manual (Page 3)

E LECTRONIC S ILHOUETTE
Page 3
Introduction
Introduction
Thank you for purchasing this Pyrox product. It has been designed to give you excellent service.
Now it is installed, you are no doubt anxious to run it and enjoy the far-reaching warmth. Before you
do, take a few minutes to read through this instruction booklet and discover how to get the very best
from your heater. After you have read it, we suggest you store these instructions in a safe place for
future reference. If you have any questions of problems relating to your new heater, do not hesitate
to get in touch with your dealer / installer or your nearest Climate Technologies office.
The Australian designed and manufactured Pyrox 5 Star Gas Silhouette Wall Furnace has been
thoroughly life tested and carries the Australian Standards gas and electrical approvals.
S AFE O PERATION
1.
Ensure this unit has been installed by a
qualified, licensed gas fitter and that the
240V power point has been installed by a
qualified, licensed electrician.
2.
It is essential to have any existing power
point to which the appliance might be
connected checked by a qualified electrician
to ensure that the power point has the
correct polarity and earthing.
3. Each Pyrox Gas heater is factory set to
operate on a particular type of gas. DO
NOT use any type of gas other than that
specified on the appliance and packaging.
4.
Clearances – See Fig 1.
4.1. DO NOT drape clothing, towels etc on
or over the heater. Maintain a
clearance of 3 metres in front of the
heater.
4.2. DO NOT place articles on or against
the Silhouette – at least 300 mm
clearance
4.3. DO NOT cover the outlet louvres of the
Silhouette.
4.4. DO NOT use or store flammable
materials near the Silhouette
4.5. DO NOT store or spray aerosols in the
vicinity of the Silhouette while it is
operating.
4.6. DO NOT use an extension cord, power
board or double adaptor with this
appliance.
5. DO NOT MODIFY THIS APPLIANCE