Avalue ESM-BYT - Manual (Page 49)

ESM-BYT User ’s Manual
ESM-BYT User’s Manual 49
Redirection After BIOS POST
Always Enable[Default]
BootLoader
The Settings specify if BootLoader is
selected then Legacy console redirection is
disabled before booting to Legacy OS.
Default value is Always Enable which
means Legacy console redirection is
enabled for Legacy OS.
3.6.2.5.2 Console Redirection Settings
Item Option Description
Terminal Type
VT100
VT100+
VT-UTF8[Default]
ANSI
VT-UTF8 is the preferred terminal type for
out-of-band management. The next best
choice is VT100+ and then VT100. See
above, in Console Redirection Settings
page, for more Help with Terminal
Type/Emulation.
Bits per second
9600
19200
57600
115200[Default]
Select serial port transmission speed. The
speed must be matched on the other side.
Long or noisy lines may require lower
speeds.
Flow Control
None[Default]
Hardware RTS/CTS
Software Xon/Xoff
Flow control can prevent data loss from
buffer overflow. When sending data, if the
receiving buffers are full, a ‘stop’ signal can
be sent to stop the data flow. Once the
buffers are empty, a ‘start’ signal can be
sent to re-start the flow. Hardware flow
control uses two wires to send start/stop
signals.