Dynex DX-LCD19 - Manual (Page 6)

6 Important safety instructions
Safety check
After completing any service or repair to your TV, ask the service technician to perform
routine safety checks to determine that your TV is in correct operating condition.
Power source
Operate your TV only from the type of power source indicated on the marking label. If you are
not sure of the type power supplied to your home, consult your TV dealer or local power
company.
Screen protection
Your TV’s screen is made of glass. Do not drop your TV or hit the glass screen. If the screen
breaks, be careful of broken glass.
Non-active pixels
The LCD panel contains almost 3 million thin-film transistors, which provide exceptionally
sharp video quality. Occasionally, a few non-active pixels may appear on the screen as a fixed
blue, green, or red point. These non-active pixels do not adversely affect the performance of
your TV, and are not considered defects.
Outdoor antenna grounding
If an outside antenna or cable system is connected to your TV, make sure that the antenna or
cable system is grounded to provide some protection against voltage surges and built-up
static charges. Article 810 of the National Electrical Code, ANSI/NFPA No. 70, provides
information with respect to correct grounding of the mast and supporting structure,
grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors,
location of the antenna-discharge unit, connection to grounding electrodes, and
requirements for the grounding electrode.
An outside antenna system should not be located near overhead power lines or other electric
light or power circuits, or where it can fall into such power lines or circuits. When installing an
outside antenna system, extreme care should be taken to keep from touching such power
lines or circuits, because contact with them can be fatal.