Avalue EPI-QM57 User Manual

Page 17

User’s Manual

EPI-QM57 User’s Manual

2.2 Installation Procedure

This chapter explains you the instructions of how to setup your system.
1. Turn off the power supply.
2. Insert the SODIMM module (be careful with the orientation).
3. Insert all external cables for hard disk, floppy, keyboard, mouse, USB etc. except for flat

panel. A CRT monitor must be connected in order to change CMOS settings to support
flat panel.

4. Connect power supply to the board via the ATXPWR.
5. Turn on the power.
6. nter the BIOS setup by pressing the delete key during boot up. Use the “LOAD BIOS

DEFAULTS” feature. The Integrated Peripheral Setup and the Standard CMOS Setup
Window must be entered and configured correctly to match the particular system
configuration.

7. If TFT panel display is to be utilized, make sure the panel voltage is correctly set before

connecting the display cable and turning on the power.

Note:

Make sure the heat sink and the CPU top surface are in total contact to

avoid CPU overheating problem that would cause the system to hang or
unstable