AutoPage C3-RS1100 OLED User Manual

Page 17

Aug/2009

C3 RS-1000 OP

Indoor Driving Paging

If the ignition switch is in the “off” position, press and hold the valet switch for 2 seconds
to page the driver. One chirp sound shall be emitted from the vehicle and the paging
melody will sound from your Remote OLED transceiver. “DRIVER PAGING” indication
will flash on the OLED screen.

Q. DOME LIGHT CONVENIENCE DELAY & SUPERVISION

The alarm with a unique feature which will turn on your vehicle dome light as following:
1.Upon disarming, the interior light will remain on for 30 seconds.
2.If the vehicle is intruded, the interior light will flash for the same duration as the siren.
Note: Turn on the ignition switch or arm the alarm will turn off the dome light.

R. IGNITION CONTROL DOOR LOCK/UNLOCK.

If the vehicles door locks have been interfaced to the security system, the system will automatically lock the
vehicle's doors when the ignition is turned “ON” and /or unlock the vehicle’s doors when the ignition is turned
“OFF”.

S. TRUNK RELEASE (CHANNEL 3) OUTPUT.

Press and hold

button on the transmitter for three seconds to remotely control the

trunk release or other electric devices.

T. CHANNEL 4/5/6 TIMER CONTROL OUTPUT

Activate Channel 4: Spin up the

switch to page

and then press the “Channel 4” button or press the

transmitter

and

buttons at the same time to active Channel 4 function.

Activate Channel 5: Spin up the

switch to page

and then press the “Channel 5” button or press the

transmitter

and

buttons at the same time to active Channel 5 function.

Activate Channel 6: Spin up the

switch to page

and then press the “Channel 6” button or press the

transmitter

and

buttons at the same time to active Channel 6 function.

U. MULTI- VEHICLE SECURITY OPREATION:

Your remote transmitter can be utilized to control multi- vehicle security system, to program the remote
control transmitter to a second vehicle, follow the instructions for Transmitter programming. All programming
parameters will be the same except for the following:
For Regular Remote Control Transmitter:

1. Prior to pushing any button on the transmitter. Press the Select

button first on the transmitter.

2. Once

button is pressed the LED on the transmitter will illuminate for 3.5 seconds to indicate the

second transmitter pin code is ON.

3. While the LED is illuminated, press any button on the remote control transmitter to control a second

vehicle security system.

For 2-way OLED Remote Control Transceiver:

A maximum of
four vehicle’s
security
systems can be
controlled by
this transceiver.

TX1

TX2

TX3

TX4