Austroflamm Chester Xtra - Manual (Page 9)

english 7 Chester Xtra
Heating in-between seasons
If you heat the stove in between seasons, when the outside
temperatures are higher, the flue gases may not be able to
escape completely and this may lead to disturbances in the
chimney draught, especially if the temperatures are rising
suddenly. The stove has to be charged with less wood then
and the primary air has to be increased so that the wood can
burn down faster (with visible flames) and thus the chimney
draught can stabilize.
Chimney fire
A chimney fire may occur, due to sooting and deposits in the
chimney, if impropes or humid fuel is used. In case of a
chimney fire close all air inlets on the fireplace/chimney
immediately and call the fire brigade. Please have an expert
inspect your chimney for cracks and air-tightness after the
burning out of the chimney.
4. THE MOST IMPORTANT SPARES—OVERVIEW
Gaskets
Description No.drawing Part number
Gasket Ø8mm
, L=1800 mm
10 710049
Gasket 8x2, L=416 mm 11 710096
Gasket 15x8, L=1950 mm 12 718571
Keramott
Description No.drawing Part number
Bottom left, Keramott 1 719171
Bottom rear, Keramott 2 719173
Bottom right, Keramott 3 719172
Rear, Keramott 4 719176
Side component left, Keramott 5 719177
Side component right, Keramott 6 719178
Wood retainer, Keramott 7 719179
Baffle plate rear, Keramott 8 719181
Grate 9 716408
Other parts
Description No.drawing Part number
Chester door 13 7119165
Door handle 14 771096
Chester door glass 15 719156
Glass cleaner ½ litre -- 640070
Stove lacquer -- 650002
Accessories
You can obtain floor plates of glass or steel or care products from your certified dealer.
IMPORTANT: Have defective parts replaced by your certified dealer. This will guarantee that your stove functions
properly and safely.
The fireplace must not be attered.
Maintenance
To clean the glass, please use a specialised product such as Thermohit glass cleaner. Lacquered surfaces are to be cleaned
only with a cloth (may be damp). Special cleaning agents should also be used for stainless steel surfaces. Only gaskets in
good order ensure the proper function of your stove!
Cleaning
The stove, flue outlets and smoke pipes should be cleaned and inspected for deposits every year – if necessary more often,
e.g. after the cleaning of the chimney. The chimney also has to be cleaned regularly by the chimneysweeper. Your
chimneysweeper will inform you of the necessary inspection intervals. An expert should inspect the stove annually.
Keramott numbering = installation instructions!