Delta A15097 User Manual

Page 12

Fig. 14

FILTER AND DUST COLLECTION
BAGS TO DRUM

1. Thread a 5/16-18 hex nut (A) Fig. 13, onto the end

of bag support rod (B). Thread rod into hole (E)
and tighten nut (A) against motor assembly to hold
support rod (B) upright. Height of support rod can
be adjusted after the filter bag is in place. The hook
in the support rod (B) should be positioned over the
drum. This can be accomplished by rotating the
support rod until the hook is positioned over the
drum (C) Fig. 13.

2. Hook the loop on the top of filter bag (F) Fig. 14,

onto the end of support rod (B).

3. Position open end of filter bag (F) Fig. 15, over the

lip of drum (G). NOTE: It may be necessary to adjust
the height of the drum support rod at this time. If
adjustment is necessary, loosen nut (A) Fig. 13, and
rotate support rod (B) as needed to obtain proper
rod height to support filter bag (F). Tighten nut (A) Fig.
13.

4. Place locking band (H) Fig. 15 around the filter bag

(F), through filter bag loops (L), and fasten filter bag
to drum by locking clamp (J) as shown in Fig. 15.
IMPORTANT: Make certain band (H) is positioned in
the channel of drum (G) before locking clamp (J).

5. Place the remaining locking band (H) Fig. 16, around

the dust collection bag (K) and collection bag loops
(M). Position open end of bag over the lip of drum
(G) and fasten with locking clamp (J). NOTE: Make
certain locking band (H) is positioned in the channel
of drum before locking clamp (J).

Fig. 13

Fig. 15

Fig. 16