Delta A15097 User Manual

Page 11

Fig. 9

SUPPORT

1. Place the support (A) Fig. 10 inside the two side

supports (B). NOTE: MAKE SURE SUPPORT IS
ATTACHED TO THE SIDE SUPPORTS CLOSEST
TO THE MOTOR.

2. Align the four holes in the support with the four

holes in the side supports as shown in Fig. 10.

3. Insert a 5/16-18x3/4" hex head screw (A) Fig. 11,

thru the side supports and the support.

4. Place a 5/16" lockwasher on the hex head screw.

5. Thread a 5/16-18 hex nut on the hex head screw

and tighten securely.

6. Repeat this process for the three remaining holes for

attaching the support.

7. Fig. 12 shows the support attached to the side

supports.

Fig. 10

Fig. 12

Fig. 11