ADLINK NuPRO-E340 - Manual (Page 27)

Hardware Information 13
NuPRO-E340
2 Hardware Information
This chapter provides information on the NuPRO-E340 board lay-
out, connector pin assignments, and jumper settings.
2.1 Rear Panel I/O Ports
Figure 2-1: Rear Panel I/O Ports
USB 3.0 Connectors
Connector Description
1 LAN1 port (RJ-45) Gigabit Ethernet (supports Intel® AMT)
2 LAN2 port (RJ-45) Gigabit Ethernet
3 VGA port DB-15 connector for CRT or LCD monitor
4 USB 3.0 ports SuperSpeed USB 3.0 ports
Pin # Signal Name
1 USB3.0_P5VA
2 USB2_CMAN
3 USB2_CMAP
4 GND
5 USB3A_CMRXN
6 USB3A_CMRXP
7 GND
8 USB3A_CMTXN
9 USB3A_CMTXP
NOTE: NOTE:
The USB 3.0 ports do not function during system boot or under
DOS and are only available after the driver is loaded by the OS.
For USB support during BIOS setup and system install, connect a
USB cable with bracket to one of the onboard USB pin headers.
1 2 3
4