ADLINK MIX-220 - Manual (Page 26)

14 Getting Started
2.4 Installing the CPU Cooler
To install the CPU cooler:
1. The CPU cooler has a layer of thermal grease
pre-applied. If you are reinstalling the CPU, apply a new
layer of thermal grease evenly to the top of the installed
CPU.
2. Position the heatsink on top of the installed CPU until the
heatsink screws match the screw holes on the board.
3. Tighten the heatsink’s spring-loaded screws in a diago-
nal sequence until it is securely attached to the board.
4. Connect the fan power cable to the CPU fan connector
on the motherboard (CPU_FAN1)
CAUTION:
An approved CPU cooler must be installed before using the sys-
tem. Failure to install a CPU cooler may damage the mother-
board and/or CPU.
CPU Fan
Connector
2.1 Installing the CPU Cooler
To install the CPU cooler:
1. The CPU cooler has a layer of thermal grease
pre-applied. If you are reinstalling the CPU, apply a new
layer of thermal grease evenly to the top of the installed
CPU.
2. Position the heatsink on top of the installed CPU until the
heatsink screws match the screw holes on the board.
3. Tighten the heatsink’s spring-loaded screws in a diago-
nal sequence until it is securely attached to the board.
4. Connect the fan power cable to the CPU fan connector
on the motherboard (CPU_FAN1)
CAUTION:
An approved CPU cooler must be installed before using the sys-
tem. Failure to install a CPU cooler may damage the mother-
board and/or CPU.
CPU Fan
Connector