Connection, 1 ide disk drive connector (ide1, ide2) – Acrosser AR-B1790 User Manual
Page 11
AR-1790 User’s Guide
11
3. CONNECTION
This chapter describes how to connect peripherals, switches and indicators to the AR-B1790 board.
3.1 IDE DISK DRIVE CONNECTOR (IDE1, IDE2)
•
IDE1: Primary IDE Connector
A 40-pin header type connector (IDE1) is provided to interface with up to two embedded hard disk drives (IDE AT
bus). This interface, through a 40-pin cable, allows the user to connect up to two drives in a “daisy chain” fashion.
To enable or disable the hard disk controller, please use the BIOS Setup program, which is explained further in
chapter 5. The following table illustrates the pin assignments of the hard disk drive’s 40-pin connector.
1
39
2 40
Pin
Signal
Pin
Signal
1 -RESET 2 GROUND
3 DATA
7 4 DATA
8
5 DATA
6 6 DATA
9
7
DATA 5
8
DATA 10
9
DATA 4
10
DATA 11
11
DATA 3
12
DATA 12
13
DATA 2
14
DATA 13
15
DATA 1
16
DATA 14
17
DATA 0
18
DATA 15
19 GROUND 20
N.C
21 PDDREQ 22 GROUND
23 -PDIOW 24 GROUND
25 -PDIOR 26 GROUND
27 PIORDY 28 GROUND
29 -PDDACK 30 GROUND
31 IRQ14 32 N.C
33 PDA1 34
PD66/100
35 PDA0 36 PDA2
37 -PDCS1 38 -PDCS3
39 HLEDP 40
GROUND