2 system settings, 1 jp5 (serirq), 2 jp1 (power on) – Acrosser AR-B1631ET User Manual
Page 8

AR-B1631ET User’s Guide
8/30
2.2 SYSTEM SETTINGS
Jumper pins allow you to set specific system parameters. Set them by changing the pin location of
the jumper blocks. (A jumper block is a small plastic-encased conductor that slips over the pins.) To
change a jumper setting, remove the jumper from its current location with your fingers or small
needle-nosed pliers. Place the jumper over the two pins designated for the desired setting. Press the
jumper evenly onto the pins. Be careful not to bend the pins.
We will show the locations of the AR-B1631ET jumper pins, and the factory-default settings.
CAUTION: Do not touch any electronic components unless you are safely grounded. Wear a
grounded wrist strap or touch an exposed metal part of the system unit chassis. The static discharges
from your fingers can permanently damage electronic components.
2.2.1 JP5
(SERIRQ)
2.2.2 JP1 (POWER ON)
JP4
CN9
LPT1
J2
DIO1
COM3
AUDIO1
CN10
JP1
JP5
CN8
CDIN1
J5
JRS1
CN4
JP6
IR1
J3
USB_A2 USB_A1
COM4
COM2
CLOSE SERIRQ
POWER BUTTON
PIN HEADER