Acrosser AR-B1661 - Manual (Page 25)

AR-B1661 Manual
24
Swap Floppy Drive
This item allows you to determine whether or not to enable Swap Floppy Drive. When enabled, the BIOS swaps
floppy drive assignments so that Drive A becomes Drive B, and Drive B becomes Drive A. By default, this field is
set to Disabled.
Boot Up Floppy Seek
When enabled, the BIOS will seek whether or not the floppy drive installed has 40 or 80 tracks. 360K type has
40 tracks while 760K, 1.2M and 1.44M all have 80 tracks. By default, this field is set to Enabled.
Boot Up NumLock Status
This allows you to activate the NumLock function after you power up the system. By default, the system boots up
with NumLock On.
Boot Up System Speed
This has no function and selects the default system speed (High).
Gate A20 Option
This field allows you to select how Gate A20 is worked. Gate A20 is a device used to address memory above 1
MB. The default setting is Fast.
Typematic Rate Setting
When disabled, continually holding down a key on your keyboard will generate only one instance. When enabled,
you can set the two typematic controls listed next. By default, this field is set to Disabled.
Typematic Rate (Chars/Sec)
When the typematic rate is enabled, the system registers repeated keystrokes speeds. You can select speed
range from 6 to 30 characters per second. By default, this item is set to 6.
Typematic Delay (Msec)
When the typematic rate is enabled, this item allows you to set the time interval for displaying the first and
second characters. By default, this item is set to 250msec.
Security Option
This field allows you to limit access to the System and Setup. The default value is Setup. When you select
System,
the system prompts for the User Password every time you boot up. When you select Setup, the system
always boots up and prompts for the Supervisor Password only when the Setup utility is called up.
OS Select for DRAM > 64MB
This option allows the system to access greater than 64MB of DRAM memory when used with OS/2 that
depends on certain BIOS calls to access memory. The default setting is Non-OS/2.
Report No FDD For WIN 95
This option allows Windows 95 to share with other peripherals IRQ6 that is assigned to a floppy disk drive if the
drive does not exist. The default setting is No.
Video BIOS Shadow
This item allows you to change the Video BIOS location from ROM to RAM. Video Shadow will increase the
video speed.