Acrosser AR-B1661 - Manual (Page 35)

AR-B1661 Manual
33
4.11 SUPERVISOR / USER PASSWORD
These two options set the system password. Supervisor Password sets a password that will be used to protect
the system and Setup utility. User Password sets a password that will be used exclusively on the system. To
specify a password, highlight the type you want and press . The Enter Password: message prompts on
the screen. Type the password, up to eight characters in length, and press . The system confirms your
password by asking you to type it again. After setting a password, the screen automatically returns to the main
screen.
To disable a password, just press the key when you are prompted to enter the password. A message
will confirm the password to be disabled. Once the password is disabled, the system will boot and you can enter
Setup freely.
Phoenix-Award BIOS CMOS Setup Utility
STANDARD CMOS FEATURES LOAD FAIL-SAFE DEFAULTS
ADVANCED BIOS FEATURES LOAD OPTIMIZED DEFAULTS
ADVANCED CHIPSET FEATURES SET SUPERVISOR PASSWORD
INTEGRATED PERIPHERALS SET USER PASSWORD
POWER MANAGEMENT SETUP SAVE & EXIT SETUP
PNP/PCI CONFIGURATION EXIT WITHOUT SAVING
ESC : Quit F9: Menu in BIOS б в а Я : Select Item
F10 : Save & Exit Setup
Change / Set / Disable Password
4.12 IDE HDD AUTO DETECTION
This option detects the parameters of an IDE hard disk drive, and automatically enters them into the Standard
CMOS Setup screen.
Up to four IDE drives can be detected, with parameters for each appearing in sequence inside a box. To accept
the displayed entries, press the “Y” key; to skip to the next drive, press the “N” key. If you accept the values, the
parameters will appear listed beside the drive letter on the screen.
Enter Password: