Acrosser AR-B1661 User Manual
Page 25
AR-B1661 Manual
23
Primary HDDs
The onboard IDE connectors provide Primary channels for connecting up to four IDE hard disks or other IDE
devices. Each channel can support up to two hard disks; the first is the “Master” and the second is the “Slave”.
To enter the specifications for a hard disk drive, you must select first a “Type”. There are 45 predefined types
and 4 user definable types are for Enhanced IDE BIOS. Type 1 to 45 is predefined. Type “User” is user-definable.
For the Primary Master/Slave as well as Secondary Master/Slave, you can select “Auto” under the TYPE and
MODE fields. This will enable auto detection of your IDE drives and CD-ROM drive during POST.
Press
hard disk will not work properly if you enter incorrect information for this field. If your hard disk drive type is not
matched or listed, you can use Type User to define your own drive type manually. If you select Type User, the
related information has to be entered to the following items.
CYLINDER:
Number of cylinders
HEAD:
Number of read/write heads
PRECOMP: Write precompensation
LANDING ZONE:
Landing zone
SECTOR:
Number of sectors
MODE (for IDE HDD only):
Auto
Normal (HD < 528MB)
Large
(for MS-DOS only)
LBA
(HD > 528MB and supports Logical Block Addressing)
NOTE: The specifications of your drive must match with the drive table. The hard disk will not work properly
if you enter incorrect information in these fields. If your hard disk drive type is not matched or listed,
you can use Type User to define your own drive type manually.
Drive A / Drive B
These fields identify the types of floppy disk drive A or drive B that has been installed in the computer. The
available specifications are:
360KB
5.25 in.
1.2MB
5.25 in.
720KB
3.5 in.
1.44MB
3.5 in.
2.88MB
3.5 in.
LCD & CRT
This field selects the type of video display card installed in your system. You can choose the following video
display cards:
Both: LCD & CRT
LCD: LCD Only
CRT: CRT Only
Halt On
This field determines whether the system will halt if an error is detected during power up.
No errors
The system boot will not be halted for any error that may be detected. (Default)
All errors
Whenever the BIOS detect a non-fatal error, the system will stop and you will be
prompted.
All, But Keyboard
The system boot will not be halted for a keyboard error; it will stop for all other errors
All, But Diskette
The system boot will not be halted for a disk error; it will stop for all other errors.
All, But Disk/Key
The system boot will not be halted for a key- board or disk error; it will stop for all
others.
Flat Panel Resolution
140 Ч 480
800 Ч 600
1024 Ч 768