Acrosser AR-B1893 User Manual
Page 27
AR-B1893 User’s Guide
AR-B11893 Pentium M inside (With VGA)
with On Board DDR, 4 Port built in LAN, 1 Mini PCI, 1 CF
27
Power Supply Type [AT]
Power On After Power Fail [Off]
Figure 3 Advanced menu
Quick Power On Self Test
This category speeds up Power On Self Test (POST) after you power up
the computer. If it is set to Enable, BIOS will shorten or skip some check
items during POST.
Enabled
Enable quick POST
Disabled
Normal POST
Full Screen LOGO Show
This item allows you to enable or disable show full screen LOGO
.
The Choice: Enabled, Disabled.
APIC Mode
This item allows use Advanced Programmable Interrupt Controller feature
.
The Choice: Enabled, Disabled.
Console Redirection
The BIOS redirects console output to COM 1 by default (9600, 8N1, no
handshake) until a bootloader program is run from the hard disk drive.
The Choice: Enabled, Disabled.
Baud Rate
This item allows you to setup the data transfer rate for the
console port.
The choice: 9600, 19200, 38400, 57600 and 115200
Agent After Boot
This item allows you to enable or disable the agent after
boot.
The Choice: Enabled, Disabled.
Swap Floppy Drive
If the system has two floppy drives, choose enable to assign physical
drive B to logical drive A & vice Versa.
The Choice: Enabled, Disabled.